TowerPlex Acrylic Bonding Primer - 5 Gallon Pail

TowerPlex Acrylic Bonding Primer - 5 Gallon Pail

TowerPlex Acrylic Bonding Primer is a 100% pure acrylic emulsion DTM primer that develops barrier corrosion resistance, normally associated only with solvent-borne primers. This product offers excellent adhesion to various substrates such as structural steel, aluminum, galvanize, concrete, masonry, and wood.

Finish:
Low Sheen

Surface Preparation:
Apply only over clean, dry and properly cured surfaces that are free of cutting solutions, form release agents, dirt, loose foreign matter and moisture. On structural steel, the substrate shall be thoroughly degreased in accordance with SSPC-SP1 standards. All burrs should be removed and sharp edges or rough weld seams should be ground down. All rust and mill scale should be removed as required by SSPC-SP6 surface preparation (minimum). For bridge construction, SSPC-SP5 is recommended.

Technical Data:

• Volume Solids: 40.86% -varies by color
• Recommended Thickness: 3 mils dry for maximum performance.

Drying Time:

• Temperature: 75 F / 55% R.H.         
• To Touch: 30 Minutes      
• To Recoat: 2 Hours     
• (Cooler temperatures and higher humidity will lengthen drying time)
• Architectural and Industrial Maintenance Category: Primers and Undercoaters
• Maximum Allowable V.O.C.: 2.9 lbs./gal. (350 g/l)
• Actual V.O.C.: .54 lbs./gal. (65 g/l) (1.22 lbs./gal. minus water + exempt materials) - varies by color

Theoretical Coverage:

• 656 sq. ft./gallon @ 1 mil dry, assuming no application loss.
• Coverage will vary depending on color, the surface texture and application technique.

Storage Temperature:

• Minimum 35 F         
• Maximum 110 F

Application:

Coverage Rates Per Coat:

Mixing:
Stir thoroughly, making sure no pigment remains on the bottom of the can.
Thinning: Thin with water.

Surface Temperature:

• Minimum 50 F         
• Maximum 90 F
• Application Equipment:
• Airless Spray
• Pressure: 1800-2400 psi
• Tip: 015"-.019"
• Conventional Spray
• Air Pressure: 60-80 psi.
• Fluid Pressure: 10-20 psi.

Cleanup:
Use soap and water.

Application Considerations:
Spray recommended. Do not apply when overnight freeze, rain or dew is forecast. NOTE: During Conditions of high humidity or moist air, allow for a much longer cure time. Warm air, moving over the substrate, will promote drying and improve cure time when less than optimum application conditions exist. When applying this coating by roller application, extra attention to detail is necessary to avoid pinholes.

Limited Warranty:
The technical data on this label or on other data is true and accurate to the best of our knowledge. We guarantee our products to conform to quality control standards. Due to misuse in handling, storage, application and workmanship or variables such as weather or surface integrity that are beyond our control, GME Supply does not authorize any representative to make any warranty or merchantability of fitness of this product. Any liability whatsoever of the manufacturer to the buyer or user of this product is limited to the purchaser’s cost of the product itself.